1、电蒸汽锅炉http://www.jnshengxin.cn/与软水器连接的管道应采用给水塑料管，排水管不得采用软塑料管，防止管道变形，影响排水效果。
Electric steam boiler pipes connected with a water softener should be used plastic water pipes, drains should not be used flexible plastic tubing, to prevent pipeline deformation, affecting drainage effect.
2、按照电蒸汽锅炉控制阀进出水箭头标记连接进出水管，采用流量型再生控制器，流量计必须安装在出水口。
An electric steam boiler control valve out of the water inlet and outlet pipe connected to the arrow mark, the use of flow-type regeneration controller, flowmeters must be installed in the outlet.
3、电蒸汽锅炉进出水管应装有压力表及手动阀门，同时还应装有旁通阀，在出水管阀前还应安装有取样阀。进水管阀后一般安装有Y型过滤器，防止管道内污物堵塞阀体造成设备无法正常运行。
Electric steam boilers out of the pipe should be fitted with pressure gauges and manual valves, but also be equipped with a bypass valve in the outlet pipe valve should be installed before sampling valve. After the inlet valve is usually equipped with a Y-type filter to prevent dirt clogging the pipeline valve cause the device to not function properly.
4、电蒸汽锅炉排水管的连接长度不应超过6m，尽量减少弯度，并严禁安装阀门。
Electric steam boiler drain connection length should not exceed 6m, to minimize camber, and are prohibited from installing the valve.
5、电蒸汽锅炉http://www.jnshengxin.cn/盐水管路连接长度不应超过2m，一定要保持良好的密封性，否则会影响软水器的再生效果。
Electric steam boilers brine pipeline connection length should not exceed 2m, we must maintain a good seal, otherwise it will affect the regeneration softener.
